Kinetixx Velocity 48" Long Drive Graphite Wood Shaft Built with Adapter & Grip

Kinetixx Velocity 48" Long Drive Graphite Wood Shaft Built with Adapter & Grip

• Kinetixx 48" Long Drive Velocity is a Mid-Balance point, High kick point advanced composite table rolled construction, that kicks hard and recover’s fast, in tailored sequence from butt to high tip. Velocity 48" Series is producing increased ball velocity and a Medium height piercing shot trajectory. Kinetix 48" Velocity was used by the 2019 Long Drive Champion Kyle Berkshire.
• Featuring Dual-Flex Reactive Technology, in the worlds only pre-loaded and vacuum cured Nano-Carbon amorphous fiber material shaft construction, table rolled laminate composite.
• Vacuum Cured to minimize resin content, optimizing elastic strength and dynamic recovery properties of the Nano-Carbon Amorphous material. Enhancing feedback and delivering an extremely forgiving shaft.
• Active butt and tip quadrants tailored for high speed long drive athletes desiring to improve efficiency and increase ball velocity, through the purest kinetic energy transfer from golfer to club.
• Kinetixx Shafts feature Vaccum-Cured Technology: Vacuum Cured to minimize resin content, optimizing elastic strength and dynamic recovery properties of the Nano-Carbon Amorphous material. Enhancing feedback and delivering an extraordinarily flexible and forgiving shaft.
• Static Curing Method vs. Vacuum Curing Process: All table rolled shafts are made with static curing method resulting in lack of control over resin contents. Limited or incomplete coverage of fibers with resin causes resin pooling, voids and fiber 'washout'. Another disadvantage is that valuable fibers are unnecessarily cut during the center-less grinding process. Kinetixx's Proprietary Vacuum Curing Process increases consistency, allows for homogenous resin to fiber coverage ratio and minimizes resin to improve fiber performance.
• Kinetixx 48" Velocity features a Low launch profile.
• Bend Point: High
• Ball Flight: Low
• Swing Speed: 
• Measure Shaft Length: Please measure the length of your current shaft (not club length) as we don't have your shaft in our store.
  • Remove shaft from your club length.
  • Remove the screw or bolt from hosel adapter
  • Measure length of your current shaft, measure length from tip end of adapter to the butt end of grip
  • Write the desired shaft length of your new shaft into the field "Shaft Length"
• This is a built-to-order assembled shaft + adapter + grip item. Please allow 3 business days for the shaft installation.
• Your new shaft is trimmed to your specification. Order cannot be cancelled once assembly has begun. No return allowed, sales are final.
• Please allow +/- 1/4 inch tolerance between new and old shaft; it is not considered a defect. 
• Note: This shaft is a Pre-Order (Non-Inventory Item). Please allow additional 5 days processing time prior to shipping.